Perko 0586S0P Manual do Utilizador descarregar pdf

Swivel Fill Limit Valves for

EPA Compliant Fuel Systems

Perko Series 0586S0P for use on Plastic Tanks

INSTALLATION INSTRUCTIONS

PLEASE READ ALL INSTRUCTIONS BEFORE PROCEEDING

These valves are for use on fuel tanks to comply with the CARB and EPA standards and

meet the requirements of U.S.C.G. Safety Standards (July 31, 2011) for 40 CFR Parts 9,

60, 80 et al. (Control of Diurnal Emissions From Nonroad Spark-Ignition Engines and

Equipment). Note: Inspect valve fitting and snap ring annually for corrosion, replace

if necessary.

These valves and receivers shown below are designed to be permanently molded into

polymer tank surfaces when the tank is manufactured.

Series 0586S0P - Fuel Limit Vent Valves (FLVV)

Note: The ullage depth is set by the tank manufacturer or OEM builder and cannot be

changed. In order to maintain compliance with the EPA and CARB requirements, these

valves that set the ullage depth cannot be interchanged with different depth valves.

For multiple ullage levels

1. Select your mounting location for valve receiver.

2. Mold the receiver into the tank and thread jam nut onto receiver and tighten.

3. Slide the valve into receiver and orient hose barb in the direction of the vent line.

Attach locking snap ring to hold valve in the receiver.

4. Attach 5/8” vent hose onto hose barb and tighten using hose clamps in accordance

with ABYC Fuel System Vent Hose Clamping Standards (H24 Table 3).

5. Replacement of the valve assembly:

a. Remove hose.

b. Remove locking snap ring.

c. Pull out valve assembly.

d. Install new assembly into receiver.

e. Attach locking snap ring.

f. Re-attach hose and tighten in accordance

to instruction 4 and check for leaks.

PERKO, INC.

16490 N.W. 13th Avenue

Miami, FL 33169-5707

www.perko.com

11/12

0586INS4

*The above referenced standards can be obtained from:

(1). American Boat & Yacht Council, Inc. (2) U.S. Coast Guard (3). E.P.A.

613 Third Street, Suite 10 Washington, D.C. 20593 401 “M” Street S.W.

Annapolis, MD 21403 (or your local C.G. office) Washington, D.C. 20460

CARB

0586S0P

Valve

Snap Ring

Receiver

Jam Nut