Perko 0584T Manual do Utilizador descarregar pdf

NPTF Dry Seal Threaded Valves for use

on Aluminum Tanks for EPA Compliant Fuel Systems

INSTALLATION INSTRUCTIONS

PLEASE READ ALL INSTRUCTIONS BEFORE PROCEEDING

These valves are for use on fuel tanks to comply with the new CARB and EPA

standards and meet the requirements of U.S.C.G. Safety Standards (July 31,

2011) for 40 CFR Parts 9, 60, 80 et al. (Control of Diurnal Emissions From

Nonroad Spark-Ignition Engines and Equipment).

Note: Inspect valve fitting annually for corrosion, replace if necessary.

Series 0584T Inlet Check Valves (ICV)

1. These valves are designed to mount into 1-1/2”

NPTF dry seal aluminum threaded receivers welded onto tanks

(receiver not supplied).

2. Thread valve into receiver. For angled fittings, orient hose barb in the

direction of the fill fitting. Do not use the hose barb as a lever to tighten

valve.

3. Attach 1-1/2” fill hose onto hose barb and tighten using hose clamps

in accordance with ABYC Fuel System Fill Hose Clamping Standards

(H24 Table 3).

PERKO, INC.

16490 N.W. 13th Avenue

Miami, FL 33169-5707

www.perko.com

10/12

0584INS1

*The above referenced standards can be obtained from:

(1). American Boat & Yacht Council, Inc. (2) U.S. Coast Guard (3). E.P.A.

613 Third Street, Suite 10 Washington, D.C. 20593 401 “M” Street S.W.

Annapolis, MD 21403 (or your local C.G. office) Washington, D.C. 20460

CARB

0584T00