Perko 1418 Manual do Utilizador descarregar pdf

PERKO, INC.

16490 N.W. 13th Avenue

Miami, FL 33169-5707

www.perko.com

Cat. Nos. 1418 Series Sealed EPA Fill

Installation and Operation Instructions

These fills meet the new CARB and EPA requirements of U.S.C.G. Safety Standards (July 31, 2011)

for 40 CFR Parts 9, 60, 80 et al. Control of Diurnal Emissions From Nonroad Spark-Ignition Engines

and Equipment.

WARNING

Do not attempt to use these non-vented EPA fills on older vented non-EPA certified boats.

Although similar in appearance, the cap on this fill is not vented

whilst the cap on the older

version is vented. The vent line attached to this body functions only with the cap open and

during the filling process.

1. Select mounting location:

- In accordance with A.B.Y.C., U.S. Coast Guard and E.P.A. requirements and regulations.

- Surface must be flat and provide adequate clearance to remove the cap.

- Allow for adequate clearance under fill for routing fill and vent hose, which must be selected and installed in

accordance with A.B.Y.C. requirements and U.S. Coast Guard Safety Standards for Small Boat Fuel Systems

(33 CFR 183).

2. Non-metallic fills do not need to be grounded or bonded.

3. Attach mounting template to selected mounting surface and orient for desired position of fill/vent connections and

for ease of insertion of the fuel nozzle into the neck. Drill where indicated, drilling the 3/4 inch hole first.

NOTE: The 2-1/16” dimension of the larger hole is sized to provide mounting surface support to fill the

body. DO NOT use larger size cutter or drill.

4. Mount fill using #10 Round head or Pan head screws. Caulk if necessary.

5. Attach and clamp fill and vent hoses, also in accordance with the above referenced requirements.

(1). American Boat & Yacht Council, Inc. (2). U.S. Coast Guard (3). E.P.A.

613 Third Street, Suite 10 Washington, D.C. 20593 401 “M” Street S.W.

Annapolis, MD 21403 (or you local C.G. office) Washington, D.C. 20460

04/11

1418INS1

Drill for #10 Screws (4)

Drill 3/4” Dia. Hole

(Drill First)

2-1/16” Dia.

(Drill Second)

Hinge Side

1-7/32”

MOUNTING TEMPLATE