Perko 9611 Manual do Utilizador descarregar pdf

Cat No. 9611 Series Basic Switch

Cat No. 9612 Series with Key Lock

BATTERY SWITCHES

INSTALLATION AND OPERATING INSTRUCTIONS

For use with alternators and generators rated 6-32 V.D.C.

Switch rating: 315 amperes continuous, 450 amperes intermittent.

All wiring to the switch shall be performed by a QUALIFIED MARINE ELECTRICIAN, and in accordance

with the “Fire Protection Standard For Motor Craft”, N.F.P.A.* No. 302, The Standards of the American Boat

and Yacht Council, Inc.*, and the U.S.C.G.* Safety Standards for Boat Electrical Systems (33 CFR 183).

CAUTION: Always STOP engines before switching to “OFF” position. Erratic operation, particularly

after very long periods of idleness, can be cleared by rapidly switching back and forth

briskly several times without any load connected.

NOTE: (1) Locate switch to keep battery cables as short as possible.

(2) If switch is to be mounted in an area subject to corrosion, it is recommended that a liquid

electrical coating be applied to the terminal connections.

(3) Mounting screw size #10 pan head or round head. Mount on a flat surface and do not

over-tighten screws to prevent deforming the switch body.

(4) Protective skirt panels can be removed as required for cable positioning when installing the

switch.

(5) Terminal stud size is 3/8 inch.

OPTIONAL ACCESSORY

Key Lock - Switch can be locked only in the “OFF” position. Key can be removed in either the locked or

unlocked position.

16490 N.W. 13th Avenue

Miami, Florida 33169-5707

www.perko.com

9611INS1

1/08

* Above referenced standards can be obtained from:

1. American Boat & Yacht Council, Inc. 2. U.S. Coast Guard 3. N.F.P.A.

613 Third Street, Suite 10 Washington, D.C. 20593 1 Batterymarch Park

Annapolis, MD 21403 (or your local C.G. office) Quincy, MA 02169

COM

Starter

DIAGRAM #1

Battery

Engine

Ground